(850) 970-2830

Attic Mold in Tallahassee: Match the Symptom to the Cause

Tallahassee roofs take a lot: long humid summers, sudden downpours, pine needles in the gutters and, every few years, a tree or a limb coming down in a storm. The attic is where the consequences quietly collect. This page is organized the way people actually find the problem, by symptom first. Find what you are seeing, read what it usually means, and then decide who to call. We are a referral service, not a roofer or a mold company, so this is a guide to good questions rather than a diagnosis.

On this page: Symptom guide · After a storm or a fallen limb · Tarps and temporary repairs · A new roof does not always end it · Humidity and ventilation · Comparing bids · Looking yourself, safely · The right order of work · Gutters and the roof edge · What you store · An attic record · A Tallahassee attic calendar · Questions

Symptom guide: what you see and what it often means

None of these is a diagnosis, because several can overlap. They are the first places a roofer, an HVAC technician or a licensed mold assessor would look.

A musty smell in a hallway or closet below the attic
Often moisture in insulation or on the roof deck, or a duct or air-handler problem that is pulling attic air into the house. The smell may get stronger when the air conditioner starts.
Brown or yellow rings on the ceiling
Water has moved through the ceiling from above. It can be an active roof leak, an old one, a leaking air-handler line or a plumbing problem. A ring that is damp to the touch is more urgent than a dry one.
Dark streaks on the underside of the roof deck
This could be mold, old water staining or ordinary discoloration. Streaks that line up with nails, vents or a roof penetration suggest a moisture path. Wide patches often mean long-term humidity or a fan that vents into the attic.
Rusty nail tips or droplets on the wood in the morning
Warm, wet air meeting a cooler surface. That is condensation, and it often points to exhaust air or humid indoor air reaching the attic.
Insulation that is matted, darker or clumped in patches
Water has reached it, either from above or from a duct. Patches under a stained deck point to a leak. Patches near a bathroom point to a fan.
Wet or dripping duct wrap, or water in the air-handler pan
A drain problem or sweating ducts. Our guide to AC vent and duct mold in Tallahassee goes deeper.
Soft, spongy or sagging roof decking
Long-term moisture. Stop and call a roofer, and do not walk on it.

The EPA's guidance is that when mold is visible, sampling is usually unnecessary and the priority is to find and fix the moisture problem. For more on when a licensed assessor adds value, see our guide to mold testing and inspection in Tallahassee.

After a storm or a fallen limb

Tallahassee's tree canopy is a big part of what makes the city attractive, and it is also why storm damage here so often means roof damage. Storms such as Hermine in 2016 and Michael in 2018 left many homes with limb strikes, lifted shingles and punctured decking. A small hole can let water in for weeks before anyone looks up.

If a limb or a tree has hit your roof, this is a sensible sequence:

  1. Stay safe first. Do not climb on a damaged roof or into a damaged attic. Look from the ground, and from the attic hatch only if the ceiling below is dry and sound.
  2. Photograph before anything moves. Take dated photos of the damage, the limb and the ceiling below, inside and outside.
  3. Call your insurer early and ask what the policy requires before repairs. Florida sets time limits for notice of a property claim, and our guide to mold and insurance summarizes them.
  4. Limit further damage. A temporary cover and moving belongings are usually expected. Keep receipts.
  5. Dry what got wet, quickly. The EPA says to dry water-damaged areas within 24 to 48 hours to prevent mold growth, and in most cases mold will not grow if wet materials are dried in that window.
  6. Get the roof properly repaired, then look again at the attic.

Mold can show up weeks or months after a storm, once a small leak has fed it. Do not assume the all-clear because the ceiling looks dry.

Tarps and temporary repairs: helpful, but only temporary

A tarp can keep water out while you wait for a roofer, and many policies expect you to take reasonable steps to prevent more damage. But a tarp can also trap moisture, hide a spreading problem and give a false sense that the job is done. If a tarp stays on for weeks, check the attic and ceiling below regularly. Ask the roofer when the permanent repair will happen, and what condition the decking is in. If the deck was wet for a while, ask whether it needs to be dried or replaced before shingles go back on.

A new roof does not always end the problem

Homeowners are sometimes surprised when mold persists after a roof replacement. The new shingles stop the leak, but they do not dry out wet insulation, clean old growth off the rafters or fix a bathroom fan that vents into the attic. Before you sign for a roof, ask the contractor:

Verify the contractor's license at MyFloridaLicense.com, and get the scope in writing. If mold is found when the deck is exposed, a licensed assessor and remediator are separate from the roofer.

Humidity, fans and ventilation: the slow causes

Not every attic problem comes from a hole. In North Florida's humid climate, the slow causes are common, and they are easy to miss.

Exhaust that lands in the attic

A bathroom fan whose duct is disconnected, crushed or simply stops short puts warm, wet air where it does not belong. General building-code guidance is that exhaust air goes outdoors and not into an attic, and a Florida Building Commission committee report has stated that venting into a vented attic does not meet the intent of the code. If you find one, photograph it and ask a licensed contractor to run it to a proper termination. The EPA recommends running the bathroom fan or opening a window when showering and using exhaust fans when cooking.

Attic ventilation

Vents are supposed to let outdoor air move through. The details depend on how your roof was built, and the Florida Building Code requirements have changed over time. Blocked soffits, insulation pushed over the vents, and boxes stacked against the eaves can all cut airflow. Some homes have sealed or conditioned attics that work differently. Ask a licensed roofing or building contractor what your attic is meant to have before anyone adds or removes vents.

Air leaking up from the house

Gaps around recessed lights, ceiling penetrations and the attic hatch let indoor, humid air reach cool surfaces in the attic. The EPA's target is to keep indoor humidity below 60 percent, ideally between 30 and 50 percent. A basic hygrometer, which is inexpensive, shows the number at a glance.

Comparing bids: three questions that cut through the noise

If you ask three companies about an attic, you may hear three different stories. These questions help sort them:

  1. Who is licensed for this part of the job? A roofer fixes the roof. A licensed mold remediator removes mold. A licensed mold assessor evaluates it. These are different licenses, and you can look each one up.
  2. Is the moisture source named and fixed first? A bid that cleans the attic but never mentions a leak, fan or duct is cleaning a problem that will come back.
  3. What is in the written scope? The area, the materials to be removed, the containment, the drying, the verification and the paperwork you will receive. See how to read a mold remediation quote.

Under Fla. Stat. § 468.8419, an assessor and a remediator from the same company generally cannot work on the same structure within 12 months of each other, with a narrow exception for certain contractors. Our overview of Florida mold laws explains why that matters when someone offers to do both.

Looking yourself, safely

You can learn a lot from the hatch with a flashlight and a phone for photos. A few rules keep it safe:

The EPA notes that roof leaks can cause hidden mold in roof materials above ceiling tiles. Look at the roof deck, around every penetration, at insulation near bathrooms, at ducts and at the air handler.

The right order of work

  1. Stop the source. Roofer, HVAC technician or plumber, depending on the cause.
  2. Document. Dated photos, readings and written notes.
  3. Assess. For significant growth, a licensed mold assessor can set the scope. Florida's licensing rules for assessment and remediation are tied to mold growth of more than 10 square feet.
  4. Remediate. A licensed remediator contains the area, removes what cannot be saved, cleans the rest and dries it. The EPA says porous materials may have to be thrown away if they become moldy, and that you should not paint or caulk over mold.
  5. Verify and rebuild. Check the result, replace insulation, and correct fans and ventilation.

For small areas, the EPA says homeowners can often handle cleanup of areas under about 10 square feet. Roof decks and attics usually are not small, so be realistic about the size.

Gutters, pine needles and the roof edge

Anyone with pines or live oaks near the house knows how fast a gutter fills. A clogged gutter overflows in the first heavy rain, and the water goes where gravity sends it: behind the fascia, into the soffit and, in the worst case, up under the lowest row of shingles. From there it can wet the end of the rafters and the edge of the roof deck, which are exactly the places you do not see from the hatch. The EPA recommends cleaning and repairing roof gutters regularly, and a gutter that is clear and draining away from the house is one of the least expensive moisture controls there is.

If you find stains at the low edge of the attic, ask the roofer to check the drip edge, the fascia and the soffit as well as the shingles. Check, too, that soffit vents are not clogged with paint, debris or insulation, since that can starve the attic of airflow.

What you store up there matters

Cardboard boxes, old papers and fabric are organic materials that mold can use, and they hold moisture longer than you might expect. If your attic is a storage space, consider plastic bins with lids, keep items off the insulation and away from the eaves, and leave a clear path to the hatch and to the air handler. Stored items also make it harder to see a problem early, which is the real cost. Before a roof repair or a mold inspection, you will need to move things anyway, so it is worth doing it on your schedule.

Keep a one-page attic record

A short, dated note turns a vague worry into something a roofer, an insurer or an assessor can use. Write down, and photograph, the following whenever you look:

If you rent, send the same photos and notes to your landlord in writing. Our guide to mold in a Tallahassee rental explains how to report it, and attic problems are generally a building issue for the owner to deal with.

A Tallahassee attic calendar

Common questions

Is attic mold a health risk?

Mold can irritate the nose, throat, eyes and skin, and people with asthma, allergies or weakened immune systems may react more. We cannot give medical advice. If you are concerned, talk to a health professional.

Will insurance cover it?

It depends on the policy and on what caused the moisture. A sudden storm event is treated differently from a long-term leak. Ask your agent early, and see our insurance guide.

Can a roofer remove the mold?

A roofer fixes the roof. In Florida, mold remediation of more than 10 square feet is a licensed activity, and the person doing it should hold the license. Verify it at MyFloridaLicense.com.

Should I spray something on it?

The EPA does not recommend routine biocide use. Fix the moisture, then clean and dry. Painting or caulking over mold tends to fail.

How do I find a licensed professional?

Send a request and an independent local company can contact you. Always check licenses yourself.

Sources and further reading

General information, not medical, engineering or legal advice. We are a referral service and do not perform mold, roofing or construction work.

Ready to talk to someone?

Send a request and we will pass it to independent Tallahassee-area companies that state they employ licensed Florida mold professionals. Send a request or call now.